El enlace fue enviado a su email.

No se pudo enviar el enlace a su email. Por favor, verificar su correo electrónico.

Ayuda en línea




The frame "Distributions" serves to define general lines or lines located on the slab surface. For these segments (lines) it is possible to display variables (deflections, moments, rotations, etc.) for an arbitrary load case or LC combination, or if needed variables for dimensioning (values of necessary reinforcement areas calculated according to the standard selected in the "Material and standards" tab).

The frame contains a table with the list of input segments (lines). Adding (editing) is performed in the "New distributions" dialog window. The window serves to specify the type of input (segment, line), coordinates of the first and the last point, load case, combination, dimensioning and quantity.

The frame displays:


General distributions

general distributions (diagrams) on an arbitrary segment (line)


Distributions on beams

if a beam is assigned to the line it is possible to display distributions (diagrams) of other quantities (shear force V3, bending moment M2, twisting moment M1)


Distributions on supported line

if the line is supported it is possible to display distributions (diagrams) of other quantities (vertical reaction rz, moment reaction rm, t).

Distributions can also be introduced using the mouse. This inputting mode is activated by clicking an appropriate button on the horizontal tool bar "Distributions". The following modes are available:

  • Add

Clicking the left mouse button on the joint introduces the distribution location.

  • Modify

Clicking the left mouse button on already existing distribution opens the "Modify properties of distribution" dialog window, which allows for modifying its parameters.

  • Remove

Clicking the left mouse button on the distribution opens the remove distribution dialog window - accepting this action removes the selected distribution.

  • Select

Clicking the left mouse button on the distribution highlights the selected distribution. The distribution is simultaneously marked in the table list. The option allows for editing several distributions at once (e.g. deleting).

The input distributions can also be edited on the desktop with the help of active objects.

Frame "Distributions"