El enlace fue enviado a su email.

No se pudo enviar el enlace a su email. Por favor, verificar su correo electrónico.

Missing captcha code. Please check whether your browser is not blocking reCAPTCHA.

Invalid captcha code. Please try again.

Ayuda en línea

GEO5

Tree
Settings
Producto:
Programa:
Idioma:

Measurement

The frame "Measurement" contains a table with a list of input measurements. The "New measurement" dialog window allows us to add measurements. The input measurements can also be modified on the desktop using the active objects.

Input measurements do not influence the actual analysis - their introduction into the program has resulted purely from designers needs. After excavating the first part of a sequential tunnel, it is useful to input the values measured in the construction site into the program and subsequently to add the excavation input parameters such that the calculated and measured values are the same.  Practical experience shows that the values of input parameters acquired from this procedure (e.g. coefficient of volume loss) are also valid for subsequent stages.

Frame "Measurement"

Pruebe GEO5.
Gratis y sin restricciones en el análisis.